|
The insersion tool I made is super simple to make, the main thing is not to push on the end of the tip. I used a #0 center drill as deep as it would go, then opened up the end with a .09" drill so it pushes farther down on the tip.
If theres a real interest in these, I can do them. The tips are super easy to insert, I put a step on the shank so that by hand they can be put in straight, then I use my drill press as an arbor press(low pressure) to insert them the rest of the way just by chucking up the tool and setting the bullet on the table.
I ran out of the delrin I had on hand, Amasingly i had exactly enough material to make all 50 tips and 2 throwaway setup tips.
Jon
|