Thread: aluminium funnel cone
View Single Post
  #4  
Old 09-09-2010, 08:21 PM
aametalmaster aametalmaster is offline
Super Moderator
  
Join Date: Nov 2005
Location: Salem, Ohio
Posts: 239
Cool
As long as you keep the compound angle the same the two cuts will be the same thickness. You just need to look at the edge of the metal as you cut for your thickness. You can mic it as you go...Bob
__________________
Bob Wright
Salem, Ohio Birthplace of the Silver & Deming Drill
http://groups.yahoo.com/group/sawking/
http://groups.yahoo.com/group/southbend10k/
http://groups.yahoo.com/group/ornamentiron/
Reply With Quote