Quote:
Originally Posted by Hoser
I have had a few people asking me about me making 300/221 brass as I have a Dillon 1050 all set up for it.
I can and am willing to do it.
If you send me your cleaned 223 brass, I will deprime it, swage out any primer crimp, cut it back to 1.355 and tumble it 100% clean again. You get your brass back.
.10 each
If you want me to touch up the neck on a Giruad trimmer, it will cut a slight VLD type chamfer and completely deburr the case. This is not needed as the Dillon run at 4,000 rpm and cuts really clean, but it leaves a square edge. The Giruad will make it perfect. If you want it run through the Giruad, add .04 each.
Depending on how much brass I have to process, I should be able to turn your brass in around 5-7 days.
I will ship it back via USPS flat rate with signature confirmation.
References avail.
|
Hoser, are you one with a video up on youtube showing your process?