Quote:
Originally Posted by jonblack
Scalce
Thanks for the reply. I have about 20k of .223 brass so I figured I would turn a couple 2-3 thousand into Whisper. I need to process the .223 brass anyway, so I was already planning on getting a RT-1200 for that. Adding the C-H trim die is affordable in comparison, so I figured what the heck.
Thanks again
jonblack
|
Ahhhhh
A brass whore after my own heart.
Are you going to just use one specific headstamp?
If you do go with the 1200 then you just need the FL sizer and seater dies along with the C&H trim die.