Well my suppressor and SBR paperwork is pending so to keep myself busy I am playing around with making some 300/221 brass.
I bought a set of Redding FL, neck, and seater dies.
http://www.midwayusa.com/viewproduct...tnumber=244465
I bought a Bench Top Cut-Off Saw to cut down my 223 brass after running through the neck sizing die without the stem.
http://www.harborfreight.com/cpi/cta...emnumber=42307
Then I FL resize with the 308 expander in it.
I then trim with a custom Possum Hollow trimmer I just received.
http://www.possumhollowproducts.com/...-trimmers.html
So far the process isn't too bad but I need to wait until I get a barrel to do large runs.
I am practicing on some old 223 brass that has loose primer pockets.
Any issues you guys can see with my steps?
Thanks