H110 is so fine, I'd doubt suck funnel. It sure looks like you got 14.5g and then 15g more. I forget how much 14.5 grains fills the case, I been using VV110 and Lil'gun for a while, staying away from 296/H110.
I think 23grains is about all you could stuff into a case even if you were trying.
H110 and W296 are the only powders which I have seen with the warnings:
Quote:
For those loads listed where a starting load is not shown, start 10% below the suggested maximum load and then approach maximums carefully, watching for any sign of pressure (difficult extraction, cratered and flattened or blown primers, and unusual recoil). H110 and Winchester 296 loads should not be reduced more than 3%.
Reduce H110 and Winchester 296 loads 3% and work up from there. H110 and Winchester 296 if reduced too much will cause inconsistent ignition. In some cases it will lodge a bullet in the barrel, causing a hazardous situation (Barrel Obstruction). This may cause severe personal injury or death to users or bystanders. DO NOT REDUCE H110 LOADS BY MORE THAN 3%.
|
Those warnings are one of the reasons I am using LilGun most of the time, the other big reason is 110/296 are almost too fine, clog up my meter.
Hodgdon page with warnings