Quote:
Originally Posted by rexmeyer
Carlo, I don't know if you remember about those dots, I could swear they are there to test the hardness of the blade to the specifications set and that they took one off the assembly line every once and awhile to do so...........I have a couple of m-9's with them, a first generation and a fourth generation one.........
|
Hi Rex,
you are very right about the small marks on the blade to test the hardness, but I was referring to the different "dots" you usually find on the pommell and the latch levers.
I create confusion as I used the word "dots" but, according to the manual (see below) the correct word should be
indentation.
Take a look at the following picture, where I marked them
and here is M9 technical manual (note that they use the drawing of an M7 pommell
)
It seems that the right release lever is supposed to be, actually, installed on the right side, as was the left on the left side.