Thread: Please Don't Laugh to Much on this!
View Single Post
  #2  
Old 04-19-2009, 01:38 PM
aametalmaster aametalmaster is offline
Super Moderator
  
Join Date: Nov 2005
Location: Salem, Ohio
Posts: 239
Cool
I would go a little bigger than the AA109 for milling. I have seen a small tee slot table on the AA lathe but it would have to be hand fit. I think it was off of a Taig. I will look for a pic...Bob
__________________
Bob Wright
Salem, Ohio Birthplace of the Silver & Deming Drill
http://groups.yahoo.com/group/sawking/
http://groups.yahoo.com/group/southbend10k/
http://groups.yahoo.com/group/ornamentiron/
Reply With Quote