Thread: Possible to bore 10mm (OD) stock to a depth of 1 inch with a hole diameter of 8mm?
View Single Post
  #2  
Old 05-17-2005, 09:16 AM
KillJoy149 KillJoy149 is offline
Senior Member
  
Join Date: Feb 2005
Posts: 111
I am assuming you have access to a Lathe???

If so, use a Boring Bar. You would work out 4MM from Center.

If you don't have a Lathe...... I don not know of a "safe" way to mantain tolerances.

KillJoy
Reply With Quote