|
The pc that I made last night just cradles one round at a time. I found a problem in that you can't count on the blade being sharp in a work environment. I was hoping to get Paid for processing my brass but it looks like it won't be reliable enough due to the morons I work with. Other than that it did work with some denting and ripping even with a dull blade.
320pf-thanks for the welcome. How much swing does that forster power trimmer have on the handle? I assume it must open and close similar to their press. Do you get any kind of OAL runout on one side without a 308 pilot?
After last night running the cases on the dillon 650 and their power trimmer sounds really good but I'd be worried about the amount of chips produced. I do run a vacuum but I guess I'd have to just do it and see
I am also thinking of making a benchrest type seater die out of a forster 7.62x39 model by just making a new case holder. I was hoping the OAL is close enough and the seater stem is the correst size. I've never seen the SSK seater dies but I assume they are the standard type like the redding. I'm getting sick of adjusting the seater die for each different bullet. I'd rather have a bunch of bullet specific seater dies. Has anyone tried to make their own seater dies in this manner?
Nick
|