Forum: AK-47 Topics
11-07-2005, 09:10 PM
|
|
Replies: 6
Views: 2,250
I installed a steel sidemount for the scope...
I installed a steel sidemount for the scope bracket which I think does the same job as the reinforcement so I will not do the plate thing at this point . But I am definitely going to do something...
|
|
Forum: AK-47 Topics
11-04-2005, 08:36 PM
|
|
Replies: 6
Views: 2,569
I put my barrel back using dry ice to chill the...
I put my barrel back using dry ice to chill the barrel ,Wh :D en it was pretty damm cold I just slid it in with a settling tap or 2 with a rubber mallet and the cross pin went right in with a small...
|
|
Forum: AK-47 Topics
11-04-2005, 08:30 PM
|
|
Replies: 6
Views: 2,250
It is the receiver reinforcement just ahead of...
It is the receiver reinforcement just ahead of the trigger .
I am going to use the low temp silver solder which goes at about 600F . This is below the critical temp for carbon steels . I know that...
|
|
Forum: AK-47 Topics
10-27-2005, 08:40 PM
|
|
Replies: 6
Views: 2,250
AK receiver reinforcement plates
I am thinking of putting a plate on my build . I am going to fabricate the plate myself and I think I will low temp silver solder it to the receiver base instead of spot welding . This should be even...
|
|
Forum: AK-47 Topics
10-26-2005, 07:46 PM
|
|
Replies: 7
Views: 1,585
Thanks guys .
I am starting...
Thanks guys .
I am starting to get the hang of all this a little . I am not trying to low dollar this project . I have been a metalworker of some kind for about 50 yrs now so I can...
|
|
Forum: AK-47 Topics
10-23-2005, 03:57 PM
|
|
Replies: 7
Views: 1,585
Very Confused
Pardon me , but this is my first AK47 build.
I have tried to figure out the part content thing , and every time I do it I get more confused . I am trying to build a Romy that is 110% legal. from a...
|
