Udrive for sale
 

these u drive screws eliminate the need for removing the barrel . Just drill 1/4 deep hole for the front tronion and set in place with hammer. the drill rear trunion 3/8 deep and set screw with hammer .Keep the rivet look without the having to push out the barrel trouble. All prices are shipped
http://www.gunco.net/gallery/data/50...m/DSCF2305.JPG
$7.00 thiere are no trigger guard screws in this set . this set perserves the rivet look
http://www.gunco.net/gallery/data/505/medium/9_00.JPG
http://www.gunco.net/gallery/data/501/medium/9_.JPG
$9.00 screws or rivets for trigger guard
http://www.gunco.net/gallery/data/50...der_folder.JPG
http://www.gunco.net/gallery/data/50...lder_rivet.JPG
$11.25 underfolder set
http://www.gunco.net/gallery/data/50...d_to_rivet.JPG
$12.00 there is no need for riveter with this set
http://www.gunco.net/gallery/data/50...m/DSCF2327.JPGanybody need rivets
http://www.gunco.net/gallery/data/50...drill_bits.JPG
http://www.gunco.net/gallery/data/50...m/DSCF2376.JPG
gas piston replacement rivets $0.75 with order or $1.00 to you door
e-clips are $0.15 with order or $1.95 for 10 shipped
center support are $2.50
drills bit are$2.00
all sets come with drill bits
You need to have your item descriptions read in very vague non-gun terms.
If using paypal
NO CREDIT CARDS PLEASE
paypal ID maximusincfl@msn.com

here is a tutorial on how to use Udrives
http://www.ar15.com/content/page.html?id=187

I got your package with these drive screws (it may have been at the post office for a while as I have been traveling for work)... They look great and I hope to bend up a flat and try these out... I need to test my Jig again anyways so no better time to try these I guess....

I'll take and post pics!