Question about Xebec jig
 

Hello to all.

Can anyone tell me how the Xebec jig clamps on to the barrel to hold it (without slipping) while the trunnion is pressed over it?

I can't tell from looking at the photos.

Thanks to anybody who can enlighten me.


Cromwell

The barrel has a narrow portion that is cut down just after the gas block and under the handguard retainer... The barrel press simply uses this larger shoulder on the barrel to support the barrel when you press. It is a simple design but works very well.

You can see it in this photo:

http://quarterbore.com/images/amdbui...pacing-08.html

and

http://quarterbore.com/images/amdbui...pacing-09.html

Both of those are from this tutorial that I have not found the time to finish yet...

http://quarterbore.com/images/amdbuild7/index.html

My question about the Xebec kit is:" WHY won't he answer emails so someone can order from him???" I WANT ONE!!! :bangin: :ak47: :D

Xebec is a full time graduate school student and he makes these in his spare time... I think he is getting busier with his classes so less time for "playing"...

AHHHHH WELLLL that explains a lot!!! :eek: :ak47: :bangin:

I'd still like a kit though......... :D

Actually I do have a couple for sale right now, and have been trying to get caught up on the e-mails. E-mail me at xebec79407@lycos.com if you are interested.

xebec

Thanks Quarterbore:

Xebec, my hat's off to you, sir.


Cromwell

Xebec--
email inbound to you sir..... :ak47: :twoguns:

Barrel installation
 

Hi, I was wondering how you make sure you have the barrel turned just right as you are pressing it into the trunion? Do you just eyeball it when you are pressing it in? Does anybody know what the interferance fit in on the barrel to the trunion? I was wondering if anybody has tried to heat the trunion and slide the barrel in by hand. Thanks Casey:sniper: