300 BLK to 300/221 Compatibility Grid - What Dies & Components Work Interchangably
 

rsilvers, I would like to know what brands are congruent for dies and chambers between the two in one place. I realize that wildcats can be all over the place, but even with the constant 5.56 to .223 comparison, there are Wylde chambers and Match Chambers that will work with both rounds yet are not perfect to either spec.

For example answering these questions would clarify a lot:

Are Redding 300/221 dies compatible to reload 300 BLK? What about Hornady or Forester? Do we have to drop another $90+ on dies so we can reload for the 300BLK?

Is a specific reamer like the Clymer or PTG compatible with full power 300 BLK ammo? If not, what is the approximate pressure difference (500 CUP or 5000 CUP) if using that chamber with 300 BLK?

Is cut Remington .223 or Lake City 5.56 Brass the same internal capacity as the factory 300 BLK brass?

I still have not seen the specs submitted to SAAMI compared side by side to the Specs for the various reamers of the 300/221 so that may clear up much of what many of us here want to know.

I think if your response was set as a sticky, it would cut down on a lot of the questions that are asked here.

I am using Redding dies for both my rifles. One is an AR .300Whisper cut with a PTG reamer the other is a Bolt gun .300 Blackout cut with a PTG reamer. same ammo both guns No problems ( well some of the Subsonic loads for boltgun dont cycle the AR) hope this helkps

Other reamers will raise pressure maybe about 4000 psi or more. You should not fire full power 300 AAC BLACKOUT ammo in older chambers.

The dies have a lot more chance of being compatible.

i8asquirrel, which redding dies? I about to order my dies with in the next week or so and Im yet to decide on which ones.

I have an AR .30/221 tp55 barrel and will be building a bolt gun in 300 Blk probly. I was leaning torge the Forster 300Blk Micrometer seater set.

I use Redding size dies and Forester Micrometer seat dies.

My SSK die set and Forester size dies are gathering dust.

Redding 300/221 dies work fine along with hosers brass for my blackout/whisper howa1500.

This is a great question. Can anyone answer what is the case volume of a cut and necked. . .

5.56 LC
.223 commercial
300 BLK Remington

dies
 

So has anyone used the Lee pacesetter dies? Just trying to save a few bucks, but also want to do it right the first time. Need to load this brass I got from Hoser :)

Or what about this set? It seems cheaper for some reason... http://www.midwayusa.com/Product/795...ngton-fireball

I have. They seem good.

There is also an FAQ which includes the list of the 58 companies making products on www.300blktalk.com