Xebec Press Kits
 

I regularly offer these kits for sale, usually in production runs of fifteen kits. It normally takes about two weeks to fill a run with paid orders and to produce the kits. I will include contact information below. The kits are the AMD kit, which work with European pattern AKM/AK-74 variants including the AMD 63 and 65, PMKMS, Romanian AKM/74 variants, Bulgarian AKM/74 variants including the late milled guns, Maadi, etc. These kits are $90.00 delivered to the lower 48 (Alaska, Hawaii, overseas will require additional shipping).

The kit includes: A barrel block that serves to hold the European
pattern AKM/74 barrel assembly during pressing, and will work with
the above listed kits (The Chinese guns are more difficult to work with
since this block bears against the "step" where the handgaurd
retainer locks into place- a step that the Chinese profile barrels
lack. With these you will have to carefully bear against the
gas block). A trunnion push block that allows you to exert press
pressure against only the strongest portions of the front trunnion,
avoiding damage to the barrel, trunnion, feed ramp, or receiver.
Trunnion support blocks for use in pressing the barrel assembly out.
A ram extension bar to facilitate the various press operations on a
12-20 ton Hydraulic press. A special punch and base set to
remove/install the barrel crosspin. Assembly anti-sieze paste. Allen
wrench and shims to adjust the trunnion push block assembly.

Quarterbore has kindly posted some pics of these tools on this thread:

http://www.quarterbore.net/forums/showthread.php?t=162

Feel free to e-mail me at xebec@lycos.com with any questions you might have about ordering, application, etc.

Thanks,
xebec

e-mail bounced
 

Is there an alternate e-mail address, I cant' get through to order.

Thank,s

I ordered and paid for one of these press kits.I will let you guys know how it works when I get it. I tried pressing the barrel on my yugo. and got it half way out but my set up is rickety.Hope the kit make the process easyer and safer.Theres a dent in the wall where the socket flew out!

This email link doesn't work - xebec@lycos.com

Regards,
Orin

Yup same here... how do we get a hold of this guy?

Found a thread on the network had this address xebec79407@lycos.com I just sent an email looking for a kit at this address, havent had time for a responce.

I recd a responce last night boys, and he is about to mfg. a few sets. Better get in touch if you need them.

Jim

Press kits
 

Sorry for the lack of attention to this thread guys-been evry busy relocating my shop. The e-mail xebec79407@lycos.com is the proper addy-sorry for the mixup. I do have a limited number of kits available still...

xebec