Brass Services / For Sale
 

I have had a few people asking me about me making 300/221/Whisper/Blackout brass as I have a Dillon 1050 all set up for it.

I can and am willing to do it.

Please keep in mind that there are many flavors of the 300 Whisper/Blackout out there. I do all the heavy lifting for you, I trim it to 1.355 and take care of the primer pocket crimp. With some chambers you can just add a primer, powder, bullet and you are good to go. Other chambers you might have to run the brass through a full length resize die. I strongly recommend doing it anyway, but that is just me. I even full length resize all brass, virgin or not. I would rather ship brass that needs the shoulder pushed back a couple thousandths than send you overworked brass that will cause headspace issues and short brass life.

If you send me your once fired and cleaned 223 brass, I will deprime it, swage out any primer crimp, cut it back to 1.355 and tumble it 100% clean again. You get your brass back.

.10 each

If you want me to touch up the neck on a Giruad trimmer, it will cut a slight VLD type chamfer and completely deburr the case. This is not needed as the Dillon run at 4,000 rpm and cuts really clean, but it leaves a square edge. The Giruad will make it perfect. If you want it run through the Giruad, add .04 each. Depending on how much brass I have to process, I should be able to turn your brass in around 5-7 days.

I can also anneal brass on my Giraud annealer. Annealing is one of those cant hurt might help kind of things. Add .02 each.

I will ship it back via USPS flat rate with signature confirmation.

References avail.

PM sent.:grin:

Back at you.

Sorry it took me so long to get the loads up and get out to the range (this is about the brass you sold me back in October), but I was out last night and that brass you made is amazing! I got my narrowest spread on velocity from any round I've loaded for any firearm.

12fps across 10 rounds with your brass, CCI BR-4 primers, 8.50gr H110, and 240gr SMK's. I didn't believe the spread after 5 (10fps spread), so loaded and shot a second 5 at the range and the total spread was 12fps for all 10. Downrange accuracy was similarly fantastic. I was only shooting at 50 yards (just doing chrono testing), but they were going in one hole.

I have clearly found the subsonic load for my AR.

Thanks again for the offer, the great price, and the fantastic brass!

Ross

Whisper brass
 

PM sent regarding Whisper brass cutting to length from 223 brass.

I am back stateside and making brass again.

All PMs replied to.

Did you make a custom trim die?

Nope. I machined a bunch off a spare 1050 toolhead to allow use of a CH4D trim die and a shop vac.

Tag - so I can find this thread later. :wink:

Brass work
 

Just wanted to give some feedback, I sent 200pcs of Lake City to Hoser, I got my brass back in less than a weeks time from when he recived it and it looks great, I checked a few and they are all perfect, clean, cut square and all the same lenght. He should charge more as the shipping for him to return the brass to me was $5 and change and he only charged me 20.00 for 200pcs anyone that doesnt give this guy some business must love brass work( personaly I would rather be shooting) again i highly recomend his services and will use him again and hope some of you do too.

Jared Costa