yes
 

this is great news!! i'm super happy for you. please please post some pics showing everything that went down here for those just starting out to understand.

tp555 is The Man ... his work is lovely ... measures Dead Nuts on! Frankly at this point if I found a measurement that I thought might be off, I'd doubt my measuring tools rather than his work.

(I have the tools to bend 3/16" and larger SS tubing for cars. Did not do well with the smaller, thick walled stuff. tp555 made a tube of the proper length from a rifle length tube using the bent section in the proper place. He then machined the rebate in the gas key end so the seal is appropriate. Beautifully done. This is a job I'd have done myself ... but the smaller of my two lathes won't quite hold the tube.)

mike

Bending the tube went easy with a cheap chino tube bender.Collets or a small 3 jaw chuck holds the tube for the relief cut.Hold the very end of the tubing in a vise so it doesn't rotate and do the bend thing.If I can get the spec for the tubing and straight material I can make the gas tubes.Easy job.