![]() |
.223 Subsonic twist rate?
Will I be looking to shoot heavy/long bullets for subsonic .223? The rifle will be a bolt gun. What twist rate, 1/7? Barrel length?
Thanks, Paul |
Hart offers a 6" twist barrel. That's the fastest I know of from any manufacturer. Sierra makes 90 grain Matchkings which should give fair wind and drop performance. I would expect that combination to work subsonic though I haven't tried it.
I'm curious though why you'd choose a subsonic 223 Rem over a subsonic 300 whisper. I would expect the performace to be inferior in every respect except maybe for having less recoil. The 223 case has way too much chamber volume to give high expansion ratio and low velocity dispersion. A 221 Fireball would be better, but still more case capacity than optimum. |
Quote:
I'm not choosing it over .300 Whisper, I"m including it along with .308 for use with my .30 caliber can (when I buy it). I plan on threading every barrel that I buy for my Savage that is .30 and under. I know that subsonic .223 will not be as quiet as it could be out of a dedicated .223 can and most of the time, I'll be shooting supersonic with the can in place but I was hoping that I could buy a barrel in a twist rate that would allow good performance either way. I didn't understand part of your answer Quote:
Thanks, Paul |
Subsonic 223 is a total waste of time. You'd be better off with a suppressed .22 rimfire. It will be safer and more reliable, not to mention a lot more fun to shoot.
|
Quote:
|
I recently started playing with subsonic .223 in a variety of bullet weights, from 40 gr. up to around 75 gr (using different rifles, with appropriate twists for the various bullet weights). I have been using Trailboss powder, as it fills the case to not quite 2/3 full.
Initial testing is good. I'm half thinking of punching a few milk jugs full of water to see if something like a V-Max or Nosler Ballistic tip will actually fragment at subsonic velocities. If so, this would be a much better round on small critters than any .22LR solid or HP. This also gives me the option to tailor the load specifically to my rifles, rather than check multiple makes and lots of .22 LR for one that gives optimal velocity from a given barrel. |
Quote:
|
Quote:
|
I'm running 68gr horn match over 4.8gr of IMR SR 4759, REM 7 1/2 primer WIN brass, out of a 20" 1/8 twist AR 5.56 chamber with the gas system closed. This load cronys in at 1010 clean barrel, after a few shots speeds increase to around 1040 works great for bustin squirles at 100yds. Oh by the way 4.8 gr of 4759 dose not soak up alot of case space. If your scared go to CHURCH!!
|
Quote:
|
All times are GMT -4. The time now is 04:22 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.