Quarterbore's Forums - Please Don't Laugh to Much on this!

Quarterbore's Forums (http://www.quarterbore.net/forums/index.php)

- General Metal Lathe Discusions (http://www.quarterbore.net/forums/forumdisplay.php?f=65)

- - Please Don't Laugh to Much on this! (http://www.quarterbore.net/forums/showthread.php?t=2146)

gcollins

10-26-2008 10:31 PM

Please Don't Laugh to Much on this!

Howdy Everyone! first off I am not a machinest! I have a 109. series Sears Lathe. I was wondering if anyone might give me a heads up, if someone has or discussed making a milling vise/attachment to use the little lathe for milling work? I have seen some of these for sale on ebay I think, but I didn't get much details. if anyone has any advice good or bad!
Please feel free to tell me what your thoughts!
Greg

aametalmaster

04-19-2009 01:38 PM

I would go a little bigger than the AA109 for milling. I have seen a small tee slot table on the AA lathe but it would have to be hand fit. I think it was off of a Taig. I will look for a pic...Bob

All times are GMT -4. The time now is 10:30 AM.