Crimp Die
 

Anyone out there know of a source for a crimp die for 300-221? I have a two dies set coming and will use this on a Dillon 550. I would like to crimp them with either a taper crimp or factory crimp. My Redding dies don't say anything about the seater die even being a crimp die at all. Besides I like to crimp as a separate step anyway. :sniper:

I was unable to crimp mine using my redding dies, I think they might be set up for a longer case length?

Jon

Jon,
I was afraid of that. Thanks for confirming it. I might have to get another Redding seat die and modify it so it will crimp since I don't see any other option.

Contact Lee Precision. They made a factory crimp die for me. I wish I could talk them into making a collet neck sizing die, that would be sweet.

Try a LEE 30 carbine factory crimp die , works for me

the redding 3-die set I got crimps with the bullet setter die.
set # 84432

What length do you trim your cases to?


Jon

I use a .308 LEE FCD with a simple height booster I turn out in a lathe.

There is no magic in the setup, the neck size is the same, only the case have different length. so turn out a piece of plastic so the whisper is suspended at the right height when the loader ram touch the bottom of the die.
As the ram pushes the crimper part, it also push the cartridge (on the booster seat) and does the crimp. No sweat :)

I called Redding and they said to order another seater and that I could use the second seater to crimp. So I did. Now I have two seater dies that screwed down until they contact the shell holder don't apply any crimp. I'm going to call Redding again and see if they will alter my die or if I need to buy a new die from elsewhere. In addition with the die screwed all the way in and the seater screwed all the way in, it will just seat 125gr Sierras to their recommended length. I might just go ahead and buy the Lee 30 M1 FCD and try it. I don't even have a barrel yet so it's no big deal to send off the die if that will solve the problem. Although, ATF cashed my check so I don't have too much longer... I hope. :eek:

Have you ever done a real bone head move? :o I made up a couple dummy rounds. I couldn't get them to crimp in the Redding dies. Then today the light bulb came on. I had two cases where my cutter slipped and they were too short. Those were the ones I used for the dummy(refers to me as well) rounds. My Redding dies crimp great with the right length of case! :o

I guess everyone is entitled to be a dumb (insert favorite noun) once in a while.