Log in

View Full Version : PSI 10x18" on wooden stand


Dutchman
12-22-2011, 01:56 AM
Greetings earthlings

My PSI 10x18" lathe. I figured a wood lathe should be on a wood bench so I built this one from rough hewn air dried Ohio oak. I like the PSI. Five speeds and it does everything I need.

http://images110.fotki.com/v109/photos/4/28344/7503119/DSCF8255b1-vi.jpg

I built these retractable caster doohinkies from scratch. My shop is small and I have to wood turn in front of the shop outside so I needed to be able to move it easy.

http://images49.fotki.com/v1509/photos/4/28344/7503119/DSCF8312b-vi.jpg

Pivoting chisel rack attaches to the 2 holes on the end of the lathe.

http://images114.fotki.com/v74/photos/4/28344/7503119/DSCF3350w-vi.jpg

Much improved tailstock clamp plate.

http://images112.fotki.com/v110/photos/4/28344/7503119/DSCF3175-vi.jpg

Swedish Mausers & Rolling Blocks
http://dutchman.rebooty.com

aametalmaster
12-22-2011, 06:53 PM
Nice job on the bench. I didn't know our Ohio Oak was any better than the rest of the states but i will take the compliment since my family has a large sawmill in Ohio :)...Bob