Shop Press Made

[aametalmaster]

I started this over 15 years ago. It sat in the corner all cut, punched and unwelded. I just had to machine the ring to hold the jack and the ram holder for the bottom. I can change tooling in a second. I removed the u joints from a junkyard driveshaft to try it out in 5 minutes. Everyone that sees it wants one but i don't think i can compete with HF Tools. Those places weren't around when i started it...Bob

[aametalmaster]

I finally got the 12T jack put on...Bob

[sha-ul]

Now THAT was a long term project.:tongue:

[aametalmaster]

Made a bearing splitter in the lathe this morning. Been wanting one for quite a while but didn't want to spend 40 bucks on ebay for one...Bob

[aametalmaster]

Lawn mower tire bead breaker...Bob

[aametalmaster]

Punch for bending flat bar...Bob