Prototype Scabbard For M9M4 HYBRID

[Mister Moon]

HERE : http://www.quarterbore.net/forums/showthread.php?t=2072

[porterkids]

Looks nice. I have two comments, actually one comment and one suggestion. The shorter the scabbard the more difficult cutting wire becomes. It's a simple matter of physics. Have you tried cutting anything with the shortened scabbard? Second, the cutter plate is now fastened to the hollow section of the scabbard body. If the screws are tightened too much is will start to crush the scabbard. I'd also be concerned about ripping the cutter plate off the scabbard body. I suggest you machine a solid block to fit inside the bottom of the scabbard. You could solvent weld it in place and then drill through it for the cutter plate mounting screws and a drain hole.

[Mister Moon]

Hi Bill,
Thanks, after reviewing your comments I agree the scabbard cutter plate mounting could be better
supported with a fill piece. Good idea, Thanks.

[Mister Moon]

... others " proto scabbard " ... (Leather scabbard & M9 sacabbard MADE by Phil' Louis)

[Mister Moon]

M9M4 proto scabbard (photo 2)

[Mister Moon]

...........................

[Carlo]

Nice work Mister Moon !
To be honest I prefer the plastic scabbard version, with the wire cutter...but this is only my personal taste.