Please Don't Laugh to Much on this!

[gcollins]

Howdy Everyone! first off I am not a machinest! I have a 109. series Sears Lathe. I was wondering if anyone might give me a heads up, if someone has or discussed making a milling vise/attachment to use the little lathe for milling work? I have seen some of these for sale on ebay I think, but I didn't get much details. if anyone has any advice good or bad!
Please feel free to tell me what your thoughts!
Greg

[aametalmaster]

I would go a little bigger than the AA109 for milling. I have seen a small tee slot table on the AA lathe but it would have to be hand fit. I think it was off of a Taig. I will look for a pic...Bob