Log in

View Full Version : New to 300 Whisper but not to variants


Cold
12-06-2007, 10:34 PM
Hi all

320Fp suggested this site to me.

I am on several other discussion sites and am looking at adding a 300 W to my collection very soon. Can anyone suggest who would have an 300 W upper on hand for sale? I have been told Del Ton and Model 1 but i am not a fan of model 1, I am going to call Del Ton tomorrow, their site however shows nothing for the 300 W.

Other then Reeds ammo, who else loads it?

Thanks to Quarterbore for a good site WITH fantastic spam regulation at sign up. I need to get that done for my own sites.

Looking to learn more soon.

Cold

pug
12-07-2007, 12:00 AM
Oly and model1 were the only ones stocking 1:8 twist 300/221 barrels that I know of. The Oly was what Tony used on the Del-Ton uppers but the last time I called they were out of them. The oly ported in the pistol position works better with a broader range of subsonic loads. The model1sales barrels are ported in carbine position and cycle only the heaviest subsonic loads but work well with supersonic loads.

jjmcrowell
12-07-2007, 06:04 AM
Delton list the 300 whisper barrels as "300 fireball"...

http://www.del-ton.com/AR_15_Barrel_p/cv1006.htm

http://www.del-ton.com/SearchResults.asp?Search=fireball

Pitt300
12-07-2007, 09:59 AM
Cold,
Don't rule out Model 1 sales!
I have one of their 300 uppers & initial supersonic loads are about 1" w/out tweaking anything. (only fired about 12 rounds total to get it sighted in & check operation of gun)
Haven't fired any subsonics yet as I won't get my can until this weekend & I did not want to "waste" the ammo by knowing that it would not cycle.
I ordered the upper "custom built" and after receiving & shooting it I realized that my AAC FH did not fit flush against the barrel shoulder @ the muzzle.
They had threaded it to 0.640" I think.
AAC specs 0.600" so I called them because I was concerned that I might get a baffle strike if everything wasn't square.
They said "Send it back"!
I did & w/in about a week I had it back ecactly as I needed.
They are now using AAC's specs for threading (at least on 5/8x24 threads).
THEIR CUSTOMER SERVICE IS EXCELLENT!
I'm now looking @ buying a 14.5" barrel in .223 & having them weld my AAC FH to it so that it will have a total length of 16+" so no SBR paperwork needed & it is the same animal!
Good luck w/your project & I WILL buy from M1S again!